Buffalo River Speedway
Buffalo River Speedway

Buffalo River Speedway
Glyndon, MN

TONIGHT at 7pm: Night of Destruction
128
7/11/2017

7/11/2017

Buffalo River Speedway


TONIGHT at 7pm: Night of Destruction

Start Time: 7:00PM
Front Gate Opens: 5:00PM

Demo Derby Rules - Buffalo River Race Park 2017 (updated 7-11-17)

  1. Cars must be stock. (small cars – wheel base 110 1/2 inches or smaller) NO pickups.

  2. Windshield may remain in vehicle or can be removed. If windshield is removed, 9 gauge wire or chain must go from roof to dash area. All other glass must be removed.

  3. All glass must be removed and swept from the vehicle, trim, door handles, plastic bumper covers, grills. Head lamps and tail lamps must be removed.

  4. Tires must be of OEM nature. NO cut tires, NO exotic tires, NO aftermarket tires. Must be stock type radial tires ONLY.

  5. Exhaust may be cut off under vehicle behind front seat – it must remain under car – no headers.

  6. Hood and trunk must be open during inspection. There must be a 12” X 12” hole in the center of the hood and trunk. 9 gauge wire or chain only to fasten hood and trunk in 6 places. 9 gauge wire or chain can go around front bumper and rear bumper in 2 places.

  7. One (1) battery only. If left in stock location – spray foam may be used. Battery must be covered with rubber floor mat. Battery may be moved inside car passenger floorboard. Must be secured and fastened.

  8. Driver’s door must have some kind of driver’s protection which will consist of plate. Must be bolted, welded, or 9 gauge wired. No extruding bolts on driver’s door protection. Doors can be chained or wired up to six (6) spots on each door. One pipe or square tubing can go behind driver’s seat. This may be the only thing that can be welded. This is for driver’s protection only.

Driver’s door must be a contrasting color from the rest of the car.

  1. Inside driver’s door must be padded.

  2. Gas tank can remain in stock location if in front of rear axle. If the gas tank is not in front of the rear axle, it must be moved to back seat area inside the car. Factory tank and pump can be used. Any gas tank inside car must be securely fastened and covered.

  3. No body creasing, folding or bending.

  4. Rear ends must be stock. No swapping of rear ends, no gear changes.

  5. Suspension – no modifications. Period.

  6. Frames – no welding of any kind. No pre-bending.

  7. Engine and transmission must be stock made and model of car.

  8. All airbags must be removed.

  9. This is back to basics – if you have spent more than two days building this car – it is over built!

  10. These are the rules – there are NO gray areas. These rules supersede any and all rules previously used. Rules and dates are subject to change without notice. THE DECISIONS OF THE

JUDGES, SCOREKEEPERS, AND OFFICIALS WILL BE FINAL.

At time of registration all drivers and pit personnel must sign a waiver and release of liability and indemnity agreement. These rules will govern all Buffalo River Race Park demo derby events. All participants must comply with these rules and regulations, it is furthermore agreed that all entries, pit crew, drivers, owners, sponsors, safety personnel, and law enforcement will comply with these rules.

No expressed or implied warranties of any kind. This is a guide set forth for the conduct of the sport and no way a guarantee against injury or death to the spectator, participant, or official. Buffalo River Race Park has the right to accept or reject any entrees without notice.


Submitted By: Mike Spieker

Back to News

Build your brand with MRP Digital Ads